[Elecraft] Help!

Fri Oct 3 12:38:00 2003

If you have a Digital Volt Meter, I would start looking at the power coming into the K2 and follow the circuit.  You will find either a component that is broke or a bad solder joint.  From what you describe, I would make sure that you have 13.8 volts going where it should.  Also, you might have a bad voltage regulator somewhere.  That means you have to trace it down to where you have voltage and where you don't.  Then look at the component and the solder joint.

Lee -K0WA

Greg Storms <[email protected]> wrote:
Hi out there. I'm working on #3434 and have stalled out on alignment and test , part 1 (page 41). When I power up nothing happens. I have been through the troubleshooting for this problem to no avail. The only additional info I can give is that as power is switched on I can here a very faint and short click, then nothing. I know I will need to go over every thing once again, maybe twice, three times, but are there any likely suspects that can be rounded up first?

Thanks in advance,

Greg
KD7SRC

--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed. To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html ---
_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---