[Elecraft] K2 Calibration problems

[Ron D'Eau Claire]

It's not clear from that procedure, but you MUST re-run CAL PLL after making
any changes to C22 for the changes to show up in the display.

What C22 does is set the frequency of the reference oscillator used by the
circuits that calibrate the dial. It does not affect the dial reading
directly. 

Ron AC7AC

-----Original Message-----
Dear all,
today I tried to optimize my K2 ('3607) by recalibrating. All went well but
the following problem occured: on the lower bands ist the TX frequency 400
HZ lower than on the display, on the higher bands the frequency is exactly
with the same difference higher. I did the 4 MHz Callibration as described
on page 57 for several times, but no change. Where is the problem? what 's
wrong?

tnx fr help

Michael, DC0ZO
K2 #3607