[Elecraft] K2 SSB Module Help

[Eric Swartz WA6HHQ - Elecraft]

Make sure you have installed the 5.6K bias resistor between pins 1 and 6 of 
the rear of the K2's mic connector as instructed in the MH-2 manual. This 
provides the 5V bias for the MH-2 condenser element.

73, Eric   WA6HHQ
----

Terry Schieler wrote:
> I am using the MH-1 Elecraft mic with all the jumpers properly
> installed on the front panel board.  CW still transmits fine, but 5W into a
> dummy load on SSB does nothing and produces no sound on a nearby receiver
> when modulated.  SSB receive seems fine.
>
> Thanks!
> 
> Terry, W�FM