[Elecraft] KDSP2 -Display KDSP2 Firmware revision

[Leonard, David]

Hi:

Last night I was getting into the "Nitty Gritty" of the KDSP2 operation. I
was doing the procedure on Page 31 to identify my Firmware revision Version
numbers.

When I performed the procedure from the SSB filters I got a strange result. 

When I go to the last displayed value (EEP) Instead of "EEP BAC1" (the
checksum) I got 

"inStnot". 

Additionally, after that whenever I hit "display" I no longer got the KDSP
values I got just the voltage/current display. 

Yet, I could still toggle thru the filter levels via XF1. 

The only way to get it back to "normal" is to cycle the power on the K2.

When I do this on CW filters, I get the expected result(s) as stated in the
manual.

Setup:  K2 with internal ATU, KDSP2, KNB2, KSB2.

It comes under the heading of "mildly curious" as I know how to avoid it
(check rev numbers from CW filter mode).

 I was just wondering if anybody else found this "feature" in their KDSP2?
Is this, perhaps, an "Auxbus Timing" issue?

73 de Dave K9FZJ

Daffynition: FEATURE - A software "bug" discovered by the Marketing
Department. 8-)




*********************************************************************
This message and any attachments are solely for the intended recipient. If you are not the intended recipient, disclosure, copying, use or distribution of the information included in this message is prohibited -- Please immediately and permanently delete.



--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---