[Elecraft] KSB2 - Done but a couple of questions

[Dennis Ponsness]

Got the KSB2 built, installed, and calibrated (I think).  I have a couple of 
questions:

1) In the Rev C-5 Errata, it says if you use a Elecraft MH2 mike, you need 
to add a 5.6k resistor from pin 1 to pin 6.  I am using a Heil BM-5 with a 
HC4 element - Do I need to do this as well?

2) I did get a signal report from a station that said I sounded a "bit high" 
- would that be due to not having the resistor installed in 1) above _or_ is 
that because of the HC4 element _or_  do I need to do some more adjusting?

Now all I have to do is wait 'till the K60XV comes out!



73

Dennis - WB0WAO

EN84ij Iosco County, Michigan
K2 #3555
Charter Member - Michigan DX Association
www.qsl.net/wb0wao
:=)

_________________________________________________________________
Surf and talk on the phone at the same time with broadband Internet access. 
Get high-speed for as low as $29.95/month (depending on the local service 
providers in your area).  https://broadband.msn.com