[Elecraft] K2 Dayton Purchase Under construction

[Harry Yingst]

> 1)  For the PLL Reference Oscillator Range test I have 13.15 and the
> range
> listed in the manual is 9.8 to 13 kHz.  Is this .15 that I am out of
> the
> range a problem?

Your Fine you just have a little extra range (mine was 13.98)

> 
> 2)  I am not getting the votage reading on Inductor L30 under the VCO
> alignment phase of the manual.  This inductor is now "bottomed out"
> and
> reads only 5.5 V.   T5 has the right number of windings on both the
> primary
> and secondary sections (16 red and 4 green) with the inductor stamped
> 1005
> on the can as per the assembly directions.  The last thing mentioned
> to
> check is C 72.  Installed in this location is small blue one stamped
> 271J.
> I believe all of these referenced checks are correct and they have
> been
> checked, rechecked and double checked......Is there anything else
> someone
> can suggest to check or is this voltage not that critical?

I ran into the same problem squeeze your turns on T5 together more so
the occupy less room and your voltage will come up.






=====
--

Harry - AB2PN

__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com