[Elecraft] How to tell if the PCB pad is bad.. thx

[Jason Hissong]

Thanks for the responses.  I clipped out U3 and pulled the remaining 
pins out while I heated the pads.  I noticed that some of the pads came 
out too (doh!) However, the solder collected in where the remaining pad 
was.  I checked for continuity to other parts of the circuit and it 
checks out (almost like the solder made a new pad???).  I also just 
ordered stainless steel dental picks from Milestone Technologies to make 
sure the holes are clear for the replacement U3 chip I will order from 
elecraft tomorrow.

BTW... after removing the chip, I put the display board back on and 
turned the K2 on.  It acts the same as when the chip was in there.  This 
further reinforces my theory that the chip was bad because of 
overheating it.

Thanks again guys... this is a great list.  You know, this whole 
experience has helped me learn more about the K2 (well, the display 
board anyway :) and with my technique of desoldering.  I always try to 
see how I learn new things from my mistakes.  Thank goodness I did not 
ruin the board... ("hello elecraft? Can I just buy the display board 
part of the K2" hehehehe)

73
Jason Hissong
N8XE