[Elecraft] Encoder installation

[Eric Swartz WA6HHQ - Elecraft]

The pins are just soldered to the small PC board on the encoder. If you pulled 
one out, just reinsert it and solder it to its pad on the encoder PCB and all 
should be OK.

73, Eric  WA6HHQ
---


Dave Fleming wrote:
> In the processing of installing the 4 wires that connet to the "encoder"
> pin # 2 (reading from left to right from the rear of the the encoder)
> pulled out due to excessive heat and while trying to remove an
> incorrectly attached wire.  I applied heat to the pin and reinserted it.
> 
> Question:  Is there anyway I can test the encloder to see that it is OK
> and/or determine if I need to replace the part.