FW: [Elecraft] Calibrating the K2

[Dan Barker]

Make any change, and then "un change" it. The change is required to make the
firmware "re-read" the frequency. The Un-change is required to make it do so
on the correct setting. Just switch the display to BFO Control Parameter
instead of frequency (tap Display). The Control parameter is a 3 digit
number, easier to remember than the frequency (5 digits) and stable (the
frequency often cycles between two nearby values).

Dan / WG4S / K2 #2456

<snip>
  What is meant by changing the BFO control by "One Count"
</snip>