[Elecraft] K2 - Full power carrier in SSB

Bob Nielsen [email protected]
Wed May 21 18:30:00 2003


Yes, that was the problem.  Thanks for the quick response.  I guess I
needed this to remind me to pay more attention to the instructions. 
The checkout and alignment has just been too non-eventful so far.

Now I know why C167 had such long leads.

73,
Bob, N7XY

On Wed, May 21, 2003 at 02:45:06PM -0700, Eric Swartz WA6HHQ - Elecraft wrote:
> Did you forget to remove C167 when you installed the KSB2? If so that will 
> route carrier RF around the SSB adapter and create the symptom you are 
> observing.
> 73, Eric  WA6HHQ
> -----
> 
> >On May 3, 2003, JR Groeger wrote:
> >
> >>I have completed a minimum, plain vanilla configuration (PTT, AF, GND 
> >>only) of the microphone header and successfully set (I think) the 
> >>coarse carrier balance adjustment. But I am unable to do the fine 
> >>carrier adjustment. When the TX is keyed in either LSB or USB I get a 
> >>steady carrier at > 10 watts irrespective of the power control 
> >>setting, no audio. 
> 
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list. 
> Postings must be plain text (no HTML or attachments). 
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

-- 
Bob Nielsen, N7XY                          [email protected]
Bainbridge Island, WA                      http://www.n7xy.net
IOTA NA-065, USI WA-028S