[Elecraft] K2 - Full power carrier in SSB

[Eric Swartz WA6HHQ - Elecraft]

Did you forget to remove C167 when you installed the KSB2? If so that will 
route carrier RF around the SSB adapter and create the symptom you are observing.
73, Eric  WA6HHQ
-----

> On May 3, 2003, JR Groeger wrote:
> 
>> I have completed a minimum, plain vanilla configuration (PTT, AF, GND 
>> only) of the microphone header and successfully set (I think) the 
>> coarse carrier balance adjustment. But I am unable to do the fine 
>> carrier adjustment. When the TX is keyed in either LSB or USB I get a 
>> steady carrier at > 10 watts irrespective of the power control 
>> setting, no audio.