[Elecraft] Front panel not aligning...

Mon May 19 17:56:09 2003

The push buttons should be OK.  There is an adjustment later.  I think
you are normal at this stage.

Bruce - W8FU

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Jason Hissong
Sent: Monday, May 19, 2003 12:14 AM
To: [email protected]
Subject: [Elecraft] Front panel not aligning...

Hi guys,

Having a ball putting this puppy together.  I finished the control board

without a hitch.  Display board, well, one of the ICs I put in backward 
(was on the dang phone.. note to self... no phone calls during 
construction). Had a great time getting it back out (U3).  I have it put

back in place properly, however, I hope I did not put too much heat on 
it when I tried to desolder it (the IC was never too hot to touch... but

it got pretty darn warm).

Anyways... the real reason I am writing is that it seems that the front 
panel and the front panel board do not align properly.  All the 
switches, displays, and dials line up to the holes, however, the mic 
connector seems to be to high which makes the push buttons above it not 
protrude out of the panel.  I double checked, and the mic connector is 
seated all the way onto the board.  Also, the spacer fits snug under the

push buttons and all of them are the same height.

Did I get a mic connector that is too high?

Pictures at:

http://www.qsl.net/n8xe/radio/images/k2/panel1.jpg
http://www.qsl.net/n8xe/radio/images/k2/panel2.jpg
http://www.qsl.net/n8xe/radio/images/k2/panel3.jpg
http://www.qsl.net/n8xe/radio/images/k2/panel4.jpg

Thanks gang!!

73
Jason Hissong
- Finishing up the front panel on K2 #3475

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list. 
Postings must be plain text (no HTML or attachments). 
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com