[Elecraft] Exact 5MHZ Channel Frequencies

Fri May 16 09:05:07 2003

Correct!!!!

--- "Deinhardt, Toby" <[email protected]> wrote:
> Hallo,
> 
> >> ...since we use the suppressed carrier
> >> frequency on all other bands.  
> >
> > Actually, all of the present ham bands are assigned that way. 
> > For example, when the FCC specifies the upper end of the 20M band 
> > to be 14350 kHz, you must set your dial frequency (suppressed
> carrier) 
> > to keep your signal within the band. Your dial should never go
> higher 
> > than 1.5 kHz below 14300 kHz for USB. Same principle.
> 
> No! The understanding in Europe, and this was part of my written
> exam, 
> is that if my signal has a bandwidth of 2.8kHz then I would in USB
> have to have my carrier at least 2.8kHz lower than 14350kHz. In other
> words no part of my signal should (ideally) be above 14350 kHz if I
> operate close to the edge of the 20m band.
> 
> vy 73 de toby
> -- 
> DJ7MGQ (ex dd5fz, dg5mgq)
> K2     #885
> k2/100 #3248
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list. 
> Postings must be plain text (no HTML or attachments). 
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

=====
Harry - AB2PN

__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com