[Elecraft] KPA100 ---> RX attentuated

Thu May 15 17:32:01 2003

Sure sounds like something is being pinched or there is a cold solder
joint somewhere which is acting up when it is flexed especially if it is
working OK while sitting beside the K2 with the shield attached.

Bruce - W8FU

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of [email protected]
Sent: Thursday, May 15, 2003 3:16 PM
To: [email protected]
Subject: [Elecraft] KPA100 ---> RX attentuated

Hello

I have since today a problem, when I put the KPA100
into the K2.

If the KPA100 is not in the K2 integrated, but all connections
are done, the RX sensitive like always, just aside of the K2

But when I put the KPA100 module into the K2 all signals
getting attentuated and the the display show HIREFL when I
kee the TX.

If I just lift the KPA100 a bit, the RX is normal again.

I have checked all the connections from the KPA100 to the K2.

Any help?

73 de Harry, DK2GZ

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list. 
Postings must be plain text (no HTML or attachments). 
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com