[Elecraft] Measuring power supply with KPA100

[Ken Wagner]

Hi Bruce:
I seem to recall that the instructions suggest putting the meter in line at 
the fuse point that you make in the power cord. For the bias adjustment, 
you won't be pulling high current so you can safely put the meter in 
without the fuse.
Good luck...
73,
Ken K3IU
At 08:54 AM 5/14/03, Bruce D. McLaughlin wrote:

>I'm at that stage in construction of my KPA100 when the PA bias should
>be set.  We are told to put the DMM in series with the + line from the
>high current power supply.  I'm thinking of pulling off the + lead from
>the power supply connector and inserting the DMM there.  Does that sound
>reasonable?  Are there any other suggestions.  I don't see how I could
>otherwise get it into series with the line except possibly to remove the
>line fuse and jury rig something here.  How is this usually done?
>
>
>
>Bruce - W8FU
>
>
>
>--- StripMime Report -- processed MIME parts ---
>multipart/alternative
>   text/plain (text body -- kept)
>   text/html
>The reason this message is shown is because the post was in HTML
>or had an attachment.  Attachments are not allowed.  To learn how
>to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
>_______________________________________________
>Elecraft mailing list: Elecraft@mailman.qth.net
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com