[Elecraft] How do I config the K2 to put out RF on the original BNC connector?

[Francis Belliveau]

On: Friday, May 09, 2003 5:12 PM
 <ke6d@juno.com>
wrote:

> ... My question to the group is how
> do I configure this K2 back to its basic form
> (so that RF can come out of the original BNC
> connector) for transmitter alignment?
>
Dan,

I do not have all the options but I can provide some guidance.
You can simple disconnect the ATU and Battery to get them out of the way.

The KAF2 needs a pair of jumpers.  If you look at the schematic for the KAF2
connection you will see how the switch that turns is off works.  Just put
two jumpers in the connectors and that option will be removed.

The KSB2 will also need some jumpers to replace it.  Check that schematic
and you should be able to see where the signals enter and exit.  Comparing
that to the K2 schematic will provide the answers.

There was an email about creating simple module replacement jumpers some
time ago.  I believe that it had a URL with it but I can't seem to find it.

good luck,
Fran