[Elecraft] Transverter & Satellite work questions?

Jack Brindle [email protected]
Thu May 8 00:54:01 2003


OK, let me throw some folks into a tizzy. I believe this can actually 
be done. I understand the main requirements to have two K2's to operate 
side-by-side each with its own transverter on separate bands and have 
them track in frequency for doppler effects. Setting up the radios 
shouldn't be too difficult to do, you just need to practice standard 
dual-operation techniques to make sure the radios don't adversely 
effect each other (desense, etc). Tracking shouldn't be a big problem, 
it just takes some software on a computer (PC, Mac, or ???) with two 
serial ports to issue VFO commands (DN, UP, FA or FB commands) to set 
the frequency on each radio as to coordinate for doppler shift. 
Shouldn't be too bad, and you don't even need a KRC2 to do it.

Wait. There must be a  good reason to use the KRC2 in this situation...
By the way, the KRC2 probably wouldn't be a good choice to try this 
operation since it doesn't have the frequency calculation capabilities 
you would need, nor can it talk to two radios simultaneously. But it 
_could_ switch your antennas and automatically send your CW QSO 
exchange for you.

On Wednesday, May 7, 2003, at 09:02  PM, Rick Tilton wrote:
> NOW for the biggie question - Would there be ANY hope of tying the two 
> K2's
> together with their transverters and have them where they will be able 
> to do
> normal tracking and inverting tracking with the two radios for sat 
> work.
> Will the KRC2 be able to do this with the right software? Basically a 
> way to
> tie the two radios together so that the freq will track normal or 
> inverting
> as it should between the two radios.  I know this would not be the most
> efficient way to do this but is it possible. Just think about this a 
> minute.
> Might not be the cheapest way to do it but what would it be like to 
> build
> your own Satellite capable radio!  The parts are there but can we tie 
> them
> together somehow so we could seek full duplex operation between two 
> K2's
> with tracking. Is there hope of getting these two to track? Of course 
> then
> maybe someone could come up with software to help with the tracking 
> for the
> two radios (Such as W6IHG radio tuner software)?  Am I """WAY""" out 
> in left
> field here?  I am not an engineer or of the such and I'm sure I've
> overlooked some giant caveat? So be kind in your answers for where I 
> may
> shown my ignorance.  But I've got to know!?

-Jack Brindle, WA4FIB
=======================================================================
MacDobs - helping to shift the paradigm for low-cost amateur astronomy.