[Elecraft] Help - K2 receiver dead

Mon May 5 22:11:00 2003

Did you have the KAF2 in and took it out to align and forgot to put back in
or missed the pins when you plugged it in.

Gregg R. Lengling, W9DHI
K2/100 SN 3075
http://www.milwaukeehdtv.org

----- Original Message ----- 
From: "Bruce D. McLaughlin" <[email protected]>
To: <[email protected]>
Sent: Monday, May 05, 2003 9:00 PM
Subject: [Elecraft] Help - K2 receiver dead

> I am in need of some help and suggestions. I built and installed the PLL
> stability mod.  It appeared to check out OK.  CAL PLL seemed to go OK.
> Unfortunately, I have no receive audio.
>
> The K2 is transmitting.  I hear the spot tone.  I hear the side tone.  I
> can see band noise on the S meter.  But absolutely no audio comes into
> the phones or the speaker.  The K2 was receiving quite normally before
> the mod. I need suggestions as to where to look and how to start.
>
>
>
> Bruce - W8FU
>
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment.  Attachments are not allowed.  To learn how
> to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com