[Elecraft] K2OOL - Need Clarification of XFIL settings

[Don Wilhelm]

Tony,

With later firmware levels, the K2 preserves the mode and filter selection
when switching from one band to another.  This is not related to the setup
of the filters and their related BFOs.

There is an independent BFO for LSB and USB; CW and CW-R; RTTY and RTTY-R.
Each mode has an independent set of 4 filters, and each filter has two
independent BFO settings.  Note that it is possible to have both BFOs for
any one filter each on one side of the carrier frequency (normal upper and
lower sideband), but they can also be both set to the same side - this is
normally an error in the filter setup, but could be used to advantage say
for use with the digital modes when one wants to create an expanded 'pseudo
passband tuning' combination.

The granularity of each setting is between 20 and 30 Hz.

Hope that helps.

73,
Don W3FPR

----- Original Message -----
This is a general question about the granularity of XFIL settings on a
per-band basis.

Can someone clarify them please?

What I need to know is, is it possible to I customize XFIL settings to the
extent that I have different settings for USB vs LSB, CW vs CWREV and Rtty
vs RttyRev?