[Elecraft] KAT100

[Steve Hull]

Hello..
Im now  the test stage of the Kat100 and I'm having=20
a little trouble..
Alignment and Test on page 27 is GOOD>.
Swr Bridge on page 28 is where the trouble starts.
The manual states there is voltage present even though there is no pwr =
connected to the tuner.
 I have NO voltage on pin 3 or 5...
Therefore I can't adjust C31..=20
Any Ideas...????
And when I enter the tune mode I get a HI REF reading
on the K2.. through a 100 watt dummy load.
When I connect the dummy load direct to the K2 I have
a SWR of 1.1.
The dummy load is good..
Then over on page 29 I have no voltage on pin 5 so I can't
adjust R4...=20
But I do have 12V on pin 8 when pwr is connected..
Im lost as usual.
Thanks for the help in advance.
Steve / AG4l
email:  AG4L@CONNINC.COM


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---