[Elecraft] KAT100 no relays switching
Kenneth E. Harker
[email protected]
Sun Jun 29 11:56:01 2003
On Sun, Jun 29, 2003 at 10:14:47AM -0500, k4zm wrote:
> Hello:
>
> My first guess would be that the leads of RFC2 were not cleaned well enough
> to make connection when you soldered them in. Check to make sure that you
> see a low resistance (0.5-1.0 ohms) across the foils that RFC2 connects to.
I checked this, and my meter shows continuity. All the toroids are from
The Toroid Guy AA3WF, so I don't really suspect them. I've visually checked
all the solder connections to see if Imissed any or if there were solder
bridges, etc., but I don't see anything that looks suspect.
Just none of the relays ever do anything.
--
----------------------------------------------------------------------------
Kenneth E. Harker "Vox Clamantis in Deserto" [email protected]
University of Texas at Austin Amateur Radio Callsign: WM5R
Department of the Computer Sciences Central Texas DX & Contest Club
Taylor Hall TAY 2.124 Maintainer of Linux on Laptops
Austin, TX 78712-1188 USA http://www.cs.utexas.edu/users/kharker/
----------------------------------------------------------------------------