[Elecraft] #3479

[pfb]

K2/100 Ser # 3479 has been complete for 10 days.  All options work.  This is
the DSP, Noise Blanker, KAT100, 160/RX ant, SSB and mic all work.

But I do have a Problem - I do not fully comprehend the pass band and tuning
aspects and the BFO alignment.

I tune in and listen to a station on the K2.  I look at that frequency
displayed on the K2 and dial in my Kenwood to the same displayed frequency
to monitor my audio and transmission.  Well - the audio I hear in the
Kenwood is garbled slightly.

Example :  K2 display reads 14242.50 and is crystal clear
 On the Kenwood if I dial in that same frequency 14242.50 and transmit on
the K2 what I hear in the Kenwood is muffled and slightly garbled.  If I
change the Kenwood VFO display to 14242.20 it sounds much cleaner and
clearer (still not perfect because of their being so close to the transmit
antenna and overload)

Can someone, please, point me to the section in the manual that can assist
in getting this setting correct.

Paul
K8QT