[Elecraft] HP48GX to KIO2

Fri Jun 20 08:21:06 2003

Basically, yes that is what it does.  Be careful though that you don't hook
up anything other than txd, rxd and signal ground.  I don't think the 48
would understand the other signal levels on the K2 cable.

On Thu, 19 Jun 2003, Jeff Burns wrote:

> I am trying to send commands to the KIO2 using my HP48GX calculator. I have
> the cable to connect the calculator to a computer. By using a paper clip I
> was able to jumper the connector to the K2 and switch the RX and TX lines. I
> successfully sent a command to the K2. Is this what a Null Modem cable does?
> 
> Jeff Burns
> AD9T
> 
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list. 
> Postings must be plain text (no HTML or attachments). 
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

NRE/COLE Test Center OH-3
[email protected] or [email protected]
Philip L. Carter, WD8QWR
wd8qwr@w8cqk.#cmh.oh.usa.na