[Elecraft] info 232 ON 160M Calibration

Sun Jun 15 15:02:01 2003

Hi

This is a holdover from the earlier firmware. The later firmware will 
calibrate all of the bands on 40 meter only. Just make sure the 40 meter 
band is selected and run the CAL PLL program. After about 5 or 10 minutes 
you will see END and it is done.

Don Brown
KD5NDB

----- Original Message ----- 
From: "Brian Wruble" <[email protected]>
To: <[email protected]>
Sent: Sunday, June 15, 2003 1:16 PM
Subject: [Elecraft] info 232 ON 160M Calibration

> Hi all:  I have just installed the 160 meter module.  The 160 Meter
> alignment steps require setting rig to 160M at 1800.10 and running CAL
> PLL.  I get the message "INFO 232".  Searching for the meaning of that,
> I find that it means you are trying to do CAL PLL and you're not on the
> 40M band.  In other words, the error message means I am supposed to be
> on 40, but the manual for the 160M module says I have to be on 160M.
> Can someone explain this?  Thanks.  de Brian W3BW
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>