[Elecraft] K2 akignment and test, part II - solved!

Sat Jun 14 21:04:01 2003

Bob,

I had the same problem - a toroid lead not stripped at the point where it
passed through the board.  I think a notation in the instructions to measure
resistance between the solder pads would be a good idea.  In my case it was
very high, which pinned down the problem solder joints.

73,
Tom, W6WW
K2 #3453

----- Original Message -----
From: "Robert J Greenwalt Jr" <[email protected]>
To: <[email protected]>
Sent: Saturday, June 14, 2003 8:16 PM
Subject: [Elecraft] K2 akignment and test, part II - solved!

> Thanks for all your answers and ideas -- I chased them all down and
> eventually found a well disguised cold-solder connection to the toroid.
Now
> everything works fine.
>
> Bob Greenwalt
> KG6QOL
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>