[Elecraft] K2 sn3552 just arrived - question about rev 2 firmware

[Edward Kenworthy]

Thanks Bob.


On 14/6/03 4:02 am, "Bob Nielsen" <nielsen@oz.net> wrote:

> On Fri, Jun 13, 2003 at 09:01:04PM +0100, Edward Kenworthy wrote:
>> Hi
>> 
>> My K2 arrived - with all the options I ordered. I've just been updating the
>> manual with the errata and had a couple of questions:
>> 
>> 1. Do I need to do anything in regards to the rev 2 firmware ? Or are the
>> installation/reference manual just for reference ?
> 
> The Rev D and E manuals already assume Rev 2 firmware so that
> information is for reference.
> 
>> 
>> 2. I assume I build the K2 as directed, basically ignoring the fact that I
>> have any options to install ?
> 
> It's best to just follow the K2 instructions.  Near the end of the
> Front Panel and RF board construction, there are instructions to
> install certain parts from a few of the options if you plan to install
> the options.  You will also be installing jumpers as if you did not
> have these options. Later, when you install the options, you remove the
> jumpers.
>