[Elecraft] K-2 S/N 3492 RF Board P1

[Vic Rosenthal]

Pat Shaughnessy wrote:
> Pg. 36 says, "Position 20-pin male right-angle connector P1 on the BOTTOM of
> the board..."
> After a long day, I plugged the connector in and made 20 beautiful solder
> joints with P1 on the TOP of the board.
> I have a soldering station, solder wick and a cheap solder sucker

Cut the plastic strip between the pins and remove each pin separately. 
Then get a replacement connector from Elecraft or a local source and 
install it on the bottom of the board.

If you had a vacuum desoldering unit or even a GC solder popper you 
could probably remove it without damage.  With a solder sucker -- maybe. 
  But the part is so cheap that it's not worthwhile doing this unless 
you are in Antarctica and there will be no mail for six months.

Vic K2VCO