[Elecraft] Re: KPA100 assembly question

Tue Jun 3 15:30:04 2003

Bole:

My shield WAS pretty well 'twisted' when I received it. I'm certain that 
this was the result of the bending and forming of the metal, but the 
standoffs worked just as they should. Feel free to use a bit of 'urging' 
when you install the shield.

73,

Tom Hammond   N0SS

At 12:01 PM 6/3/03, you wrote:
>[snip]
> > Remember to put the two shorter standoffs at the front edge of
> > the heatsink,
> > corresponding with the reduced height of the shield in this area. This is
> > explained in the instructions.
>
>Wayne,
>
>It seems that those two standoffs are some 2 mm too short. Maybe my PCB and
>the shield are warped more than usual. :-)
>
>73 Bole, 9A3RR
>
>
>_______________________________________________
>Elecraft mailing list: [email protected]
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com