[Elecraft] KDSP2 - 20 Pin Header Insertion

[Dean Maples]

After completing my KDSP2 (everything went fine), I saw that the 20 pin
header on the DSPx module did not fully seat onto the board. The manual says
something like 1/16" gap. After reading several of the posts on the 20 pin
header issue, I'm wondering if I too have the same problem. The KDSP2 seems
to work well (functions described and performance on the air).

What is the gap other's have experienced of a "fully" seated DSPx module on
the KDSP2 board? I see 20 gold pins on mine, while the other smaller
connector at the bottom of the DSPx module (top view looking down on the RF
board) is fully seated.

Comments, suggestions would be appreciated.