[Elecraft] Re: KDSP2 problem

[Vic Rosenthal]

Lyle Johnson wrote:

> Unbutton the radio and see if it works again.  Make sure no cables are
> routed too tightly behind the DSPx module that might cause things to get put
> under mechanical strain.  If it is a K2/100, be sure the foam tape in
> correctly in place and that the pressure from the tape is pushing the DSPx
> into the KDSP2 and not pushing the whole assembly down toward the RF board.

All OK.

> If you have a remote KAT100 connected, disconnect it and see if the KDSP2
> works again.

Bingo!  It was connected to a KAT100 which is not in use now, so it was 
powered down.  Disconnecting the interface cable made it work.  I 
haven't tried it yet, but I bet connecting power to the KAT100 would 
have made it work as well.  Thank you!!!!

> I assume this is the latest version, with MCU firmware 3.00?

Yes.

Vic K2VCO