[Elecraft] Thermistor Drift Correction

Thu Jul 10 02:07:59 2003

Pat

The wires are to go through the holes in the main board where RP3's leads
originally went. The thermistor board is a bit of a snug fit among other
components but does fit and works well.

73 Dave, G4AON
K2 #1892 c/w thermistor board

----- Original Message ----- 
From: "Pat Shaughnessy" <[email protected]>
To: "Elecraft" <[email protected]>
Sent: Thursday, July 10, 2003 1:47 AM
Subject: [Elecraft] Thermistor Drift Correction

> I am on good old page 47 lower right hand side of the page where the
> thermistor board is to replace RP3.
>
> Are the leads sticking out of this little board in all directions (I
thought
> per the build instructions) supposed to come down over the component side
of
> the board and plug into RP3's holes from left to right? I think this is
> correct; but it seems a little shakey to me.