[Elecraft] KAT2 Question

[Wolf-Ruediger Juergens]

Hello again,
I could not see any sideeffect from how I have mounted the lock washers.
The KAT2 is working now. I had only a small "problem".
I loose about a hour to solve a nonexistent problem.Was looking for a
voltage at pad B.
No 3 - 4V at pad B during tune.
Then I found out that I should measure on pin1 of U4 instead on pad B, hihi.
Again a fine job from Elecraft, no real problems, exept the above, during
building of this module. Tomorrow I will try out several wire antennas, to
find out the capabilities of the KAT2.

73 Wolf, DL2WRJ (still waiting for the KDSP2)
K1 #1136, K2 #2857