[Elecraft] TX/RX Discrepancy

[Don Brown]

Hi

If you cannot find a problem anywhere else I think I would do a hard reset
on the K3 by holding 4,5 and 6
while powering on. Write down all of your filter settings before doing this
so you can reset them. You will need to run CAL PLL also.  This is a lot of
work so check everything else first.

Don Brown
KD5NDB

----- Original Message -----
From: "Trevor Day" <Trev@secornwall.com>
To: <elecraft@mailman.qth.net>
Sent: Tuesday, January 21, 2003 12:48 PM
Subject: [Elecraft] TX/RX Discrepancy


> Hi Guys,
> I am currently setting up the filters on an early (ish) K2 #1330
> recently acquired by a friend.  Whilst doing this I have found that the
> Tx and Rx frequencies are around 800 Hz apart (Tx high) and I have so
> far been unable to find the reason.  C22 adjustment for freq accuracy
> has no effect. I have trawled previous postings but can't find any
> reference to it.   I expect I'll find the cause eventually, but as I am
> not keen on re-inventing the wheel, has anyone a cure for this?
> Thanks as always
> Trev G3ZYY
> --
> Trevor Day