[Elecraft] Tuning - CW and CW Reverse?

[JAKidz]

Greetings:

> >Am I right, meaning that I can use CW / CW revere comparison to
> >zero in on a CW signal, or, as is often the case, am I missing something
> >here?
>
> There can be up to a 20 Hz - 30Hz tonal difference is 'properly' aligned
> filters between CWN and CWR. This is due to the granularity of the
> frequencies read by the DACs (digital to analog converters) used
> in the K2.

	Tuning WWV at 10mhz, checking with another receiver set to AM to make sure
the signal was in the segment without the tone, I have the 20 - 30 hz offset
and I can tune it closer by zerobeating with SPOT. So far I have trouble
using SPOT to zero beat CW, the tones being too short for me to get the
beat, and as a result I think I can tune better by bringing the tones from
CWN and CWR closer in pitch. My inexperience with CW is likely showing.
Maybe another function for an LED above LOC?

> >Also, I managed to wear a hole through the black finish of the . . .
> I'll leave that response to someone who has a clue... I'm clueless.

	Maybe I'll just leave it as sort of a badge.

73,
John, K7JG.