[Elecraft] K2 as IF Rig: Options Help Please

Tue Feb 25 12:02:01 2003

Probably because there is no xvrtr board, at least not that I have heard of.

Phil

On Tue, 25 Feb 2003, Mark S. Adams, P.E. wrote:

> Hi Gang,
> 
> I need to determine the best way to go in setting up my new K2 for use as 
> an IF rig for 50-1296MHz using DEMI transverters.
> 
> Is anyone using the trasverter board option, and if so, where are you 
> getting the PTT or transmit ground signal to switch the transverter to xmit?
> 
> Or is it easier just to turn off the KAT2 (which I'll begin building 
> tonight) and use a KAT2 port for TX and the 160M ant connector for RX? 
> DEMI xvtrs will work fine with low level IF drive OR at a few watts.
> 
> Yes, I have seen the tech notes on the site, but why isn't there info on 
> the xvtr board?
> 
> Thanks,
> Mark K2QO
> 
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list. 
> Postings must be plain text (no HTML or attachments). 
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

NRE/COLE Test Center OH-3
[email protected] or [email protected]
Philip L. Carter, WD8QWR
wd8qwr@w8cqk.#cmh.oh.usa.na