[Elecraft] K2 - RF Board U3 Installation

[Ned Asam]

You are OK -- just as long as all the pins have good electrical connection.

Ned,  KC2FLM, K2 SN 467

At 09:55 AM 2/15/2003 -0500, Gordon & Lois Duff wrote:
>I did a very poor job of installing U3.  It is tight against the PCB at the
>pin 4 end, but much further off the PCB at the pin 1 end.  Is this critical?
>I have tried removing the IC with solder wick, but I don't think I will be
>successful.  If I really need to fix it, I will go that route - can I leave
>it as is?  SN 3108.
>Gordon, KA2NLM
>
>
>--- StripMime Report -- processed MIME parts ---
>multipart/alternative
>   text/plain (text body -- kept)
>   text/html
>The reason this message is shown is because the post was in HTML
>or had an attachment.  Attachments are not allowed.  To learn how
>to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
>_______________________________________________
>Elecraft mailing list: Elecraft@mailman.qth.net
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com