[Elecraft] K2 - RF Board U3 Installation

[Gordon & Lois Duff]

I did a very poor job of installing U3.  It is tight against the PCB at =
the
pin 4 end, but much further off the PCB at the pin 1 end.  Is this =
critical?
I have tried removing the IC with solder wick, but I don't think I will =
be
successful.  If I really need to fix it, I will go that route - can I =
leave
it as is?  SN 3108.
Gordon, KA2NLM


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---