[Elecraft] Control Panel resistance checks?

Sat Feb 8 14:15:00 2003

Hi Tom,

C7 will not affect the resistance readings.

The points you named are all very high resistance points and the actual
measured value will depend on the kind of meter you use (because the test
voltage applied will vary from meter to meter) and the orientation of the
test probes.

I measured 1.8 meg ohms on all these points on my K2.  The main thing is
that you don't have an unusually low value ( less than 100K ) which might
indicate a solder bridge somewhere. Looks like you're okay :-)

73/ Bob - AG5Q

----- Original Message -----
From: "C T Morton" <[email protected]>
To: "Elecraft" <[email protected]>
Sent: Saturday, February 08, 2003 12:37 PM
Subject: [Elecraft] Control Panel resistance checks?

> Hello,
> Am doing resistance checks on control panel...manual page 20;
> The Capicator C7 is missing and being sent from company.
> I am not getting any reading from the following:
> U6 pin 13 or 14
> U8 pins 2,15,16
> Looking at the schematics, C7 is in AGC circuit and wonder if it somehow
> affects the other readings.
> Any suggestions? Went over board w/magnifying light and doesnt appear to
be
> any bad solder connections nor bridges.
>
> Help.
> Tom
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com