[Elecraft] Scan doesn't jump

Wed Feb 5 11:37:00 2003

I have seen this too. Sometimes, it is difficult to tell if the jump 
happened when I use Scan Resume, as the word SCAN on the 
display prevents me from observing what the frequency is doing.

Chuck

Note W B Reese's stunning brilliance and Chuck's apt reply (gack!)

To:             	[email protected]
From:           	W B Reese <[email protected]>
Subject:        	[Elecraft] Scan doesn't jump
Date sent:      	Wed, 05 Feb 2003 08:06:08 -0800

> Dear Fellow Elecrafters,
> 
> I have a K2 that doesn't "jump" a half KHz when I press scan resume on 
> PF1.  Instead, it just "sits" where it is & locks up the scan.  In 
> addition, when it stops on a station, it doesn't resume automatically after 
> 10-15 seconds.  It will stay on the station until I move the VFO.
> 
> Gary told me that adjusting the S meter might have some effect on this.  It 
> is supposed to be adjusted in the CAL FIL sub menu Hi or Lo for one "S" bar 
> below the left most bar & one "S" bar below the top most bar.  I've played 
> with it up and down from those recommendations, but no joy.
> 
> Can anyone advise me on this?
> 
> Thanks & Very 73,
> 
> Tracy WB6TMY S/N 0838
> [email protected]
> 
> 
> 
> __________________________
> 
>   E-Mail: - [email protected]
>   Tel: - - - - - - - - - - - 707-321-0004
>   Fax: - - - - - - - - - -  707-527-8124
> 
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list. 
> Postings must be plain text (no HTML or attachments). 
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com