[Elecraft] K2: R9 of control board out of spec?

[Don Wilhelm]

Oliver,

The K2 will work with the higher value - the only consequence is that the
internal voltage may be a bit on the low side (by less than 5%).  You can
get the correct value from Elecraft, and you apparently have a DMM that is
you can use to take the voltage readings during your alignment and test.

OTOH, do check your eratta sheet, there could have been a recent change that
I did not notice.

73,
Don W3FPR

----- Original Message ----- >
> I just start building a K2 (#3893) and found R9 on the control board out
of
> spec. It is reading 842K Ohm instad of 806K (1%). Do I have a replace this
> resistor or does it work with the wrong rating?
>
> thanks in advance
>
> Oliver, DL1EJA
>
>