[Elecraft] K2 VCO Alignment

[K6WV]

Hi.

I've been assembling K2 #3812 for a couple of weeks now as time allows.  =
I Just completed RF board assembly part 2 and am doing alignment and =
test, part 2.  Everything up to "VCO Alignment is in spec".  However, =
during "VCO Alignment" I find one out-of-spec VCO voltage reading.  My =
"40M Low Freq. Voltage" is 1.22 V and the recommended minimum is 1.5V.  =
All other voltages are within spec. at between 2.0-4.0V.=20

Now my question.  The manual indicates this may be due to an incorrect =
VCO capacitor, varactor diode or inductor.  Assuming I used the right =
parts, could I have damaged a component while soldering?  Can anyone =
point me to the likely component given the fact that only the 40M low =
freq. is out of range?

Thanks in advance,
Jon K6WV

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---