[Elecraft] Re: Elecraft digest, Vol 4 #374 - 78 msgs

[Julian (G4ILO)]

Rich, I don't understand this. The wrong sideband problem was fixed 
several updates ago. If it wasn't, my macros to spot a signal wouldn't 
work, on the upper bands, because they'd move the VFO in the wrong 
direction (which they did, before Nick fixed it, because he wasn't aware 
that the K2 changed sidebands above 17m.) Also, the frequency displayed 
is the audio receive frequency so it takes account of any offset between 
the receive cursor position (in the waterfall display) and the CW pitch 
frequency.

I'm running MixW 2.10 with Elecraft K2 selected. In CW mode, click just 
above the waterfall where the frequency is displayed, and it will change 
to show the audio frequency. If you do this on 20m and 15m then you 
should see that the direction of the display is reversed (low to high, 
vs high to low) showing that MixW is aware of the sideband reversal.

In my CAT settings. I have "CW via CAT command", "CW out via soundcard" 
and "CW is LSB" all unchecked. "Dig (Yaesu) is" LSB. "CW pitch" is 800Hz 
(my current sidetone setting.) "Display zero beat frequency" is 
unchecked. All the values under "Cat correction" are zero. Try these 
settings and report back if it fixes the problem.

BTW, I'd like to hear from anyone who has figured out a macro to change 
the CW keying speed, send something and then change it back again. When 
I do it, it seems as if the speed change commands are executed before 
the code is sent, so they cancel each other out.

73,

Julian, G4ILO. RSGB, ARRL, G-QRP. K2 SN: 0392.
G4ILO's Shack: http://www.qsl.net/g4ilo

"Rich Lentz" <ke0zx@cox.net> wrote:

I have been using MixW2 for more than a year. Great foe PSK, RTTY, SSTV.
BUT frequency is off and has been if you Select the Elecraft K2 in the CW modes.  [snip]