[Elecraft] Help: Flashing F in cw mode

Tue Aug 26 20:25:05 2003

Fritz:
  You have the Fast Play facility working.  That's what the F indicates. 
The reason you're getting FPLY 4 when you push the pre/att button is 
because it is now programmed for fast play, i.e., single button play.  You 
must have already programmed PF1 or PF2 to toggle FPLY on and off.  So, to 
turn it off, and regain the regular use of pre/att, press and hold either 
PF1 or PF2 to toggle FPLY off.  This is all documented in the manual that 
comes with the version 2 Firmware upgrade.

best wishes,

dave belsley, w1euy

--On Tuesday, August 26, 2003 12:17 PM -0700 Fritz Schewe <[email protected]> 
wrote:

> I've been away from my K2 for a while and I having memory problems ( my
> memory) on how to operate. I 'm experiencing two problems;
> 1.  In the cw mode display I see c then every so long an F appears.  Also
> the u and l are flashing in SSB mode.. 2.  In the cw mode I can't get the
> pre/att to switch, all I get is a message "FPLY 4"   Ican switch pre/att
> in the SSB modes.
>
> I've been reading all the up grades instructions for Audio filter/Real
> time Clock, Aus I/O module, KNB2 Noise blanker. etc and nothing jumps out
> explaining how I got to the above conditions.  i know I've seen the
> flashing F before, but I can't rember why it happens.
>
> Can anyone help me?  Please email me direct "[email protected]"
>
> Thanks
>
>
>
>
> Fritz Schewe AD6G
> PO Box 1009
> Gualala, CA  95445
>
>
>
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see:
> http://mailman.qth.net/mailman/listinfo/elecraft Elecraft Web Page:
> http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm

----------------------------------
David A. Belsley
Professor of Economics