[Elecraft] RE: K2 Dial Calibration Information

[Wayne Burdick]

Changing either the filter bandwidth or BFO setting will trigger a re-count/save
of the present BFO frequency. I'll clarify the manual on this point on the next rewrite.

73,
Wayne
N6KR


> -------- Original Message --------
> Subject: Re: [Elecraft] RE: K2 Dial Calibration Information
> Date: Thu, 7 Aug 2003 14:52:29 -0400
> From: "Don Wilhelm" <w3fpr@peoplepc.com>
> Reply-To: "Don Wilhelm" <w3fpr@peoplepc.com>
> To: "Wallace, Andy" <awallace@mc.com>
> CC: "Elecraft" <elecraft@mailman.qth.net>

> Andy,
> The information I have understood is that the firmware does not write the
> BFO values until the BFO frequencies are actually changed - on that basis,
> changing the filter bandwidth would only write the new filter bandwidth to
> the table, but not the BFOs.
> 
> I may have understood incorrectly all this time, but until Wayne tells me
> differently, I will continue with that assumption.
> 
> If you were successful - have you considered that it may have worked 'just
> because'?
> 
> 73,
> Don W3FPR