[Elecraft] KDSP2 Excellent! One question

Sun Aug 3 10:08:01 2003

Tim
For best results at any given bandwidth, the K2's filters and the
KDSP2 should have the same center frequency.
73, Bob N6WG

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Tim
Sent: Saturday, August 02, 2003 12:36 PM
To: Elecraft Reflector
Subject: [Elecraft] KDSP2 Excellent! One question

Hi folks -
  I must admit I was a little dubious about buying the KDSP2 module. That
was BEFORE I installed it in my K2/100. It is FABULOUS and worth every
penny!!!!!  It also went together without any hitch - not even the 20 pin
connector problem that some ran into. (I will keep the KAF2 in my other K2
for comparison and no power drain.).
  I have one question.  Does the default center frequency have any impact on
any other settings in the K2 system.?  Is there any   aspwect of the
standard filter settings (ie without DSP, sidetone, etc.....that needs to be
coordinated with the center frequency on the DSP. I'm so unclear on this it
is hard to even formulate a question. I believe the answe is no to all of
the above, but want to make sure. Thanks folks.
  Suggestion for Elecraft - a means to access DSP on/bypass using the PF
buttons?
73/Tim NZ7C

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com