[Elecraft] K1 front panel resistance check J1 pin 16 low

Sat Apr 19 22:48:00 2003

Hello,
     Thanks! I am now about to start receiver alignment, and haven't had any trouble. (Thirty hours and counting... but lots of fun.)
     -Mark Fickett, KB3JCY

=================

From:� 	"Don�Brown"�<[email protected]>
Subject:� 	Re:�[Elecraft]�K1�front�panel�resistance�check�J1�pin�16�low
To:
<[email protected]>,�<[email protected]> �

Hi

There are a lot of variations in ohm meters. They will all agree out of
circuit but when measuring in circuit, semiconductors will affect the meters
differently. You may try reversing the leads or use a different range to see
if the readings are closer to the manual. If not, I would not worry about
it. The voltage measurements are more important and they should be very
close to the manual.

Don Brown
KD5NDB

____________________________________________________________
Get advanced SPAM filtering on Webmail or POP Mail ... Get Lycos Mail!
http://login.mail.lycos.com/r/referral?aid=27005