[Elecraft] Control board questions

Mon Sep 16 23:16:01 2002

Hi

On page 14 last step you are to install wire jumpers in R18 and R19 (or p=
ut another way zero ohm resistors). When or if you install the Audio filt=
er board you will remove these jumpers. The extra holes you see are plate=
d through holes so signals can get from one side of the board to the othe=
r. They do not need to be filled with solder or have anything in them.

Don Brown
KD5NDB

----- Original Message -----
From: nr5a
Sent: Monday, September 16, 2002 8:49 PM
To: [email protected]
Subject: [Elecraft] Control board questions

Just finished putting the resistors on the board and I notice a place for=
 R18 and R19. I've used the resistors in the control board bag. I did the=
 inventory and came out with all part accounted for. Whats the deal with =
R18&R19?

Also I noticed an extra hole around R8 & R9. Also have extra holes around=
 R16,R17 and R20. What is this for? Guess I could thumb thru the manual a=
nd see if I see anything but someone has to keep you guys on your toes! h=
i

Jerry - NR5A

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---
_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list. =20
Postings must be plain text (no HTML or attachments). =20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---