[Elecraft] KPA100 Page 43 test results

Tue Sep 10 21:48:00 2002

Rick:
  I don't know about the .1v on J3, but, if I remember correctly, I got a 
reading very much like the -26.5 vdc on U4.  It's within 10% of spec. so I 
just went ahead.  Everything is working fine.

best wishes,

dave belsley, w1euy

--On Tuesday, September 10, 2002 4:16 PM -0700 Rick Wheeler 
<[email protected]> wrote:

> I am currently building the KPA100 for my K2 ser no. 2005. Two of the
> four test results on page 43 are slightly out of range. D13 cathode is
> 122 VDC: OK. U4 pin 8 is -26.5 VDC: range is -5 to -25. TP1 is 0 VDC:
> OK. And J3 + lead is .1 VDC: range is 0 only.
>
> What could cause U4 and J3 to be out of spec? I know these are only
> slightly out of spec but "numbers is numbers". Power supply voltage to
> the K2 is 14.1 VDC (as measured from the same DMM). The fan did go on
> and stay on if that means anything.
>
> Thanks,
>
> Rick Wheeler
> K4LX
> K2 No. 2005 all the options...
>
> __________________________________________________
> Yahoo! - We Remember
> 9-11: A tribute to the more than 3,000 lives lost
> http://dir.remember.yahoo.com/tribute
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

----------------------------------
David A. Belsley
Professor of Economics