[Elecraft] KPA100 Page 42/43

[Lee Buller]

We duh....I should have thought of the DMM measurement.  Thanks for the 
tip.  I don't think I did the mod, but I will take a quick measurement 
here.  THanks

Lee


At 10:26 AM 9/7/02 -0400, you wrote:
>Lee:
>  If you installed Crf, you would remember.  It required cutting a trace 
> and soldering Crf between pin 2 of P6 and one end of the cut trace.  Not 
> a task likely to be forgotten.
>
>  However, if you are still not sure, it is easily tested whether Crf is 
> installed without removing the bottom heat shield.  Open the top and 
> measure the resistance between pin 2 of P6 and the center of J4, the 
> antenna jack.  If Crf is installed this will appear open.  If not it will 
> show zero resistance.
>
>best wishes,
>
>dave belsley, w1euy
>
>--On Saturday, September 7, 2002 8:05 AM -0500 Lee Buller 
><k0wa@swbell.net> wrote: