[Elecraft] KPA100 Page 42/43

Sat Sep 7 10:35:00 2002

Lee:
  If you installed Crf, you would remember.  It required cutting a trace 
and soldering Crf between pin 2 of P6 and one end of the cut trace.  Not a 
task likely to be forgotten.

  However, if you are still not sure, it is easily tested whether Crf is 
installed without removing the bottom heat shield.  Open the top and 
measure the resistance between pin 2 of P6 and the center of J4, the 
antenna jack.  If Crf is installed this will appear open.  If not it will 
show zero resistance.

best wishes,

dave belsley, w1euy

--On Saturday, September 7, 2002 8:05 AM -0500 Lee Buller <[email protected]> 
wrote:

>
>
> ON pages 42 and 43 of the KPA 100 manual, it discusses Crf.   I cannot
> remember ... but was that modification around when the installation of
> KAT2 and the KBT2 or is that something really new because of the KPA100.
> I have it all installed but cannot remember if the capacitor is there and
> I am not looking forward to taking off the bottom, heat sink of the
> K2...just to check.  Anyone have a comment?
>
> Lee -K0WA
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list. Postings must be plain
> text (no HTML or attachments). See:
> http://mailman.qth.net/mailman/listinfo/elecraft Elecraft Web Page:
> http://www.elecraft.com

----------------------------------
David A. Belsley
Professor of Economics